Gembird EG-PM2-LAN Manual de usuario descargar pdf (Pagina 60)

EG-PM2-LAN PROGRAMMABLE POWER

OUTLET STRIP WITH LAN INTERFACE

All brands and logos are registered trademarks of their respective owners

10. Troubleshooting

Problem

Solution

The rocker switch turns off.

The load connected to the device is too

high, some of the devices connected to

the EG-PM2-LAN should be disconnected

before the rocker switch can be turned on.

The switching command is not

carried out, the rocker switch

and indicators are not lit.

There is no power supply to the EG-PM2-

LAN. Please, make sure the EG-PM2-LAN

is connected to the power supply and the

rocker switch is switched on.

The status of EG-PM2-LAN in

Power Manager does not

become Connected

Try to ping the device (see section 6.1

above)

EG-PM2-LAN is connected to

local network (ping test is ok)

but not responding.

Reset EG-PM2-LAN by pressing the

Reset button on the side control panel

(see Figure #2 above) or switch it off and

then on again using the Main rocker

switch Z (see Figure #1 above).

Connection to EG-PM2-LAN is

lost. It seems something is

wrong with its IP address.

Make sure EG-PM2-LAN is connected to LAN

and switched on. Launch Find EG-PM2-LAN

utility. You can also try to use IP config (C)

button to let the device renew its IP address

(see section 3.2 above)

1 2 ... 55 56 57 58 59 60 61 62 63 64 65

Sin comentarios

Gembird EG-PM2-LAN Manual de usuario Pagina 60