Gembird EG-PM2-LAN Manual de usuario descargar pdf (Pagina 40)

EG-PM2-LAN PROGRAMMABLE POWER

OUTLET STRIP WITH LAN INTERFACE

All brands and logos are registered trademarks of their respective owners

 To remove the LAN device, select it and click the Remove button.

You can select multiple LAN devices using Ctrl and Shift keys. You

can also remove all LAN devices by clicking the Clear button

HINT: Use the popup menu which can be activated by the right

mouse button click over the table.

If the status of EG-PM2-LAN shows the device not to be Connected

- it could be due to the following reasons:

 Incorrect IP/Port/Password specified in the Add LAN device window

 PC is not connected to the local network

 You are trying to access EG-PM2-LAN from the PC which is not

allowed to do so. Change PC IP address or change IP filter list in

EG-PM2-LAN hardware settings (see section 4.5 above)

 EG-PM2-LAN is not connected to local network. To check if EG-

PM2-LAN is on your local network you can do so-called ping test:

 Go to Start->Run

 Type cmd

 Type ping <EG-PM2-LAN IP Address specified in utility> in

the window which would appear

Suppose EG-PM2–LAN with IP address 192.168.2.189 is connected

to the local network. Then the cmd window will look as shown on the

Figure #18 below:

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 64 65

Sin comentarios

Gembird EG-PM2-LAN Manual de usuario Pagina 40